![]() ![]() Place the tank below the faucet and start the water rinse – fill the tank with running water (approx. It's quite a foul smell and obviously not healthy.ġ0. Drain the bleach fix into the measuring jug marked for the purpose. Inverse the tank every 30 seconds for 4 minutes (if you're on the combined timer, you should do this until it hits 7 minutes and 15 seconds).ĩ. From now on the temperature is not as important the bleach fix has greater latitude and you don't have to keep this at 38,5 degrees C – anywhere between 30 and 39 will do (I usually remove the bleach fix and stabilizer bottles from the waterbath as soon as I've started developing and just place them to one side it gives me more room to manouver when I inverse the tank).Ĩ. At 3 minutes and 10 seconds, drain the developer into the measuring jug marked for the purpose (you will reuse the chemicals for at least 8 rolls, so it's sound financial advice to take good care of the chemicals: as soon as you can, use the funnel to pour them back into the bottles and seal them up again).ħ. Inverse the tank immediately four times and repeat this every 30 seconds, and do by all means submerge the tank in the water while you're resting your wrists – it'll help keep the temperature even.Ħ. Developer stays in for 3 minutes and 15 seconds. It might take you fifteen seconds to pour all the developer in, but never mind that – this time is included in the overall time for development.ĥ. Once the thermometer hits 38,5–39 degrees C, start pouring the developer into the tank at the same time as you start your timer. Watch the thermometer and prepare to start the process when it reaches 39 degrees C (ideal temperature is 38,5 degrees C for C-41 – at least the Tetenal I use – but there is half a degree latitude and the extra half degree makes no earthly difference.)Ĥ. You don't want cold plastic to cool of the chemicals too rapidly once you get going.ģ. Hold the Paterson tank in the waterbath while you wait so as to warm it up a bit, making sure no water enters the tank of course. ![]() five minutes (this will warm the chemicals to the same temperature as the waterbath surrounding it).Ģ. I load the film the way I usually do (I'll not get into that now, but 500 ml chemicals will submerge one 120/220 roll or two 135 rolls).ġ. I set up all my equipment as you see it, using the kitchen sink. Oh, by the way: the image above has lots of notes, so make sure to check them out if you're interested too. I use the Tetenal Colortec C-41 set mix the chemicals to the specifications provided in the set you use and adapt the following to suit your needs (if, for instance, your C-41 set uses separate bleach and fix). ![]() This is the way I do it, not necessarily the best way – but it works for me. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |